bathroom sink drain assembly

36 views

bathroom sink drain assembly

bathroom sink drain assembly – Though there isn’t much discussion regarding the drop-in sink, it is recognized by many home owners since it is used so frequently. The reason for their popularity isn’t just their shear affordability; but since they’re more easily installed into almost any inventory countertop.

When you are prepared to set a drop in bathroom sink into your bathroom or kitchen, it can look a bit overwhelming. With some attention and determination, it won’t be that hard in any way. First, select the ideal sink. When choosing a sink bear in mind that you need a model that closely matches the sink hole in your cabinet. The process of installing the sink doesn’t need many resources, but does demand crawling under the sink cabinet. Please have the following tools prepared: 1/4 inch screws, open ended wrench, faucet kit, flex water lines, screwdriver, jigsaw, plumber’s tape, and silicone.

To start the installation of a drop in bathroom sink make sure that the hole at the counter matches the sink. If the sink is bigger than the hole at the counter you’ll need to make the hole bigger. To do this, measure the width of this sink from front to back. Make sure that you measure from the exterior edge of the sink. Next, measure the other way from side to side. Make sure that you leave 1/2 inch for the sink to sit on the counter. To achieve this you may wish to subtract one inch of the two measurements you took. After you’ve measured the sink you need to measure the counter hole.

As soon as you’ve the perfect fit between your drop in bathroom sink and the counter top you are prepared for the next step. Before you mount the sink into the counter first you need to install the faucet. This can make it simpler than installing the sink while lying on your back under the counter top. Also, go ahead and install the water line which runs from the sink into the water lines in the floor. To install the faucet you need to remove the nut in the base of the faucet. Put the faucet at the holes of this sink and then twist the nuts into the bottom of the sink. This may cause the nuts or the faucet to crack. Next, attach the flex lines into the bottom of the faucet. You will want to wrap technicians tape around the threads to help prevent leaks. In the end, use your wrench to tighten the flex lines.

Carry your drop in bathroom sink and set it in the hole you’ve made in the counter. Don’t screw it in position. You can buy all the drain piping in a simple to install kit. Once more make sure not to over tighten. Now you are prepared to guarantee the sink into the counter. Under the sink you’ll find brackets that screw into the bottom of the counter. Make certain that you have screws which aren’t too long or too short, and twist the sink into the counter. Last, you may wish to check for leaks. In case you have leaks tighten your lines a bit more.

This helps keep water from getting under the sink border and into your cabinet. You can use a paper towel or your finger, to smooth the silicone out and eliminate any excess. Congratulations! You’ve installed your own drop in sink.

Gallery for bathroom sink drain assembly

unusual bathroom sinks
single stainless steel sink
single basin kitchen sink
3 compartment sink drain